50-Ohm - Dummy Load - DC to 500 MHz
The OPEK DL-60 Low-Loss RF Termination with an integral PL-259 connector which allows direct connection to the transmitter. No coaxial cable required. It's aluminum air-cooled heatsink absorbs 60-watts peak, and 20-watts average power. 50 Ohms (±5%). Covers DC to 500 MHz with an average SWR of less than 1.15:1.
- Impedance: 50-Ohm *
- Cont. Power: 20-Watts
- Max. Power: 60-Watts
- Frequency: DC to 500 MHz
- VSWR: 1.10:1 (150 MHz)
- VSWR: 1.15:1 (250 MHz)
- VSWR: 1.20:1 (450 MHz)
- Connector: UHF-Male (PL-259)
- Connector: Gold Plated Brass Alloy
- Mfg. Test Results - Click Here
Remarks: * Average impedance ±5% (DC current) when tested with a typical multimeter. | See Mfg. Test Results
Other DetailsSee warranty details above
3 Reviews Hide Reviews Show Reviews
Small, easily portable. Performs as advertised. Has quality look and feel.
Easy to hookup anywhere.
This is a straightforward dummy load, handy for those cases where you need to test at low power without radiating a signal.
It's well made, and fits nicely on an SO-329. I can't say I really stress tested it, but it didn't overheat with moderate power, and the RigExpert sees it as 50 Ohms.
One caveat - if you use a barrel connector to mate it with, say, the PL-259 end of a cable, it can be tricky to get it off the barrel when you're done.